DSC IT-230 Manual de instalación

IT-230RS-422Interface Modulev2.0Installation ManualWarning: This manual contains information on limitations regarding product use andfunction and info

9[675] Lifestyle Zone 25 - 32 Toggle OptionsThe default for each Lifestyle Zone Toggle is ON.[676] Lifestyle Zone 33 - 40 Toggle OptionsThe default fo

10[685] Notification Zone 25 - 32 Toggle OptionsThe default for each Notification Zone Toggle is ON.[686] Notification Zone 33 - 40 Toggle OptionsThe

11Programming Options [011] Installer Code Default (CAFE) Valid range: 0000 - FFFF.|____|____|____|____|[021] Account Code Default (FFFFFF) Valid

12END USER LICENCE AGREEMENTIMPORTANT - READ CAREFULLY: DSC Software purchasedwith or without Products and Componentsis copyrighted and is purchased u

13Limited WarrantyDigital Security Controls warrants the original pur-chaser that for a period of twelve months from thedate of purchase, the product

14

FCC Compliance StatementCAUTION: Changes or modifications not expressly approved by the manufacturer could voidyour authority to use this equipment.T

1Note to Installers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2General. . . . . . . . .

2WARNING Please Read CarefullyNote to InstallersThis Warning contains vital information. As the only individual in contact with system users, it is th

3IMPORTANTThis manual shall be used in conjunction with the Alarm Controller PowerSeries Panel manual; All the safetyinstructions specified within tha

4This IT-230 Interface is fixed and shall be installed in the Panel by Service Persons only. (Service Person is definedas a person having appropriate

5WARNING! THE IT-230 INTERFACE OUTPUT CIRCUITS ARE POWER LIMITED. DO NOT ROUTE ANY WIRINGOVER THE CIRCUIT BOARD. MAINTAIN AT LEAST 25.4MM (1IN.)

6The Interface has 2 yellow LED indicators: 1 Trouble LED, 1 Network connection status LED, The LED mean-ings are described in this Section.Yellow Tro

7The Programming Sections in this document are accessed via panel Section for Ethernet/GPRS Programming.Enter: [*][8][installer code][851][###], Where

8[662] Interactive Port Settings ToggleProgram this section Toggles to select the Parity used for Interactive data transfers:[1] Parity EnableDefault