DSC Envoy NT9010 Guía de instalación descargar pdf (Pagina 19)

Chapter 2: Advanced Programming

Section 2.1: Programming the NT9010

The chapter describes how to use advanced programming. For instructions on using Flash Programming, please

see Chapter 1: Quick Set Up Guide.

2.1.1 How to Enter

Advanced

Programming

You can use the Advanced Programming to set all communicator and system

options. The Installer Code is [5555] at default, but should be changed to prevent

unauthorized access to programming.

Step 1: From any keypad enter [✱][8][Installer Code].

• The System light will flash and the Armed light will turn on to indicate you are

in programming

• The NT9010 will announce “To use Flash Programming press 1. To bypass Flash

Programming press 2.”

Step 2: To skip Flash Programming and go to the advanced programming sections,

press [2].

Step 3: Enter the 3-digit section number you want to program.

• The Armed light will turn off and the Ready light will turn on to indicate the sys-

tem is ready for the information for the selected section

• You can use the Forward (Playback) button to go forward through the advanced

programming data. The Backward (Record) button will not work in the

advanced programming sections, except for sections [301] to [303], and [402].

Step 4: Sections [802], [804], or [807] have 2- or 3-digit sub-sections. To access

programming in these sections enter the programming sub-section number.

NOTE:

If the section number entered is not valid, the NT9010 will sound

an error tone and say the section number that was entered.

Installer Code . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [006]

2.1.2 Programming

Decimal Data

When the Ready light is ON the NT9010 is waiting for the information to be pro-

grammed for the selected section.

If a digit is entered for each program box in a section the system will automatically

exit from the section. It will turn OFF the Ready light and turn the Armed light back

ON.

You can also press the [#] key to exit a section before entering data for every box.

This is handy if you only need to change the first few program boxes. All other loca-

tions in the section will remain unchanged. If the [#] key is pressed the system will

turn OFF the Ready light, turn ON the Armed light and exit from the section.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

Sin comentarios

DSC Envoy NT9010 Guía de instalación Pagina 19