DSC WLS900 El manual del propietario descargar pdf (Pagina 11)

5M - Trouble Conditions

The system monitors itself automatically for trouble conditions. Your system may still be armed with a

trouble condition present, but beware the system may not operate as expected. If you were unable to

correct a trouble condition, contact your installer for assistance.

Trouble Display Cause What You Should Do

“Controller Batt” “Controller Battery”. Low backup Call your installer for assistance

battery in the Controller

“Controller AC” AC power supply to the Controller Ensure Controller transformer is

has been interrupted plugged in. If this does not correct

the problem, call for service

“Sounder 1 AC Flt” AC power supply to the

FirstFirst

First Sounder Ensure Sounder’s transformer is

has been interrupted plugged in to the wall outlet and the

unit itself. If this does not correct

the problem, call for service

“Sounder 2 AC Flt” AC power supply to the

SecondSecond

Second Sounder Ensure Sounder’s transformer is

has been interrupted plugged in to the wall outlet and the

unit itself. If this does not correct

the problem, call for service

“Telephone Line” Telephone line connection has Ensure the telephone line is plugged

been broken or disconnected into the Controller. If this does not

correct the problem, call for service.

“Fail to Com” “Failure to Communicate”. Call your installer for assistance

The Controller has been unable to

call the monitoring station

“Loss of Clock” Controller has lost both AC and Refer to Section 7A for instructions

battery power, and upon power up on resetting the clock. If this is not

has a loss of clock (clock is reset) possible, call for service

5N - Sensor Low Battery

This message will be displayed if sensors on the system report low batteries.

This message will be displayed before allowing you to arm the system.

When the Keypad displays a message allowing you to arm the system, press

the

-YES Key to arm the system, or press the -NO Key to view the list

of sensors with low batteries.

Press the -YES Key to view the list of sensors with low batteries. When

viewing the list of Sensors with low batteries, press the

-YES Key to scroll

to the next Sensor. When you are finished reviewing the list, press the

NO Key. Your system may be armed when sensors report low batteries.

Sensors with “Low Battery” conditions may stop functioning while the system is armed.

Any Sensor that reports “Sensor Low Batt” should have its batteries

replaced. Refer to “Replacing Batteries” in Section 9 for information on the

types of batteries to use in each Sensor, and for instructions on how to install

them.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comentarios a estos manuales

Sin comentarios

DSC WLS900 El manual del propietario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad DSC WLS900