DSC PC580 - V2.3 Manual de instalación descargar pdf (Pagina 16)

O T H E R P R O G R A M M I N G

To restore the PC5132 programming to the factory default settings, perform the

following:

1. Enter [✱][8] [Installer’s Code].

2. Enter programming section [996].

3. Enter the Installer’s Code, followed by [996] again. Press [#]. The software for the

receiver section will be restored to its factory default settings.

4. Press [#] to exit Installer Programming. After a software default, you must exit and

then re-enter Installer Programming before attempting to program the receiver

section.

For instructions on restoring the default programming of the control panel or any other

connected module, see your system

Installation Manual

O T H E R P R O G R A M M I N G

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Sin comentarios

DSC PC580 - V2.3 Manual de instalación Pagina 16