DSC PC1575 Manual de instalación descargar pdf (Pagina 6)

Upon completion of downloading, the LINKS1000 will ‘hang up’. The LINKS1000 will automatically disconnect

any call after a 20 minute duration.

Emergency Phone Number

This number is programmed into the LINKS1000 and will be dialed when the AUX IN terminal is shorted to

ground. To program the number, enter the emergency phone number into the LINKS1000, exactly as it would

be dialed on a cellular phone. To use this feature, place an ordinary handset in parallel with the panel on the

LINKS1000 T-1, R-1 terminals and connect a normally open pushbutton across the AUX IN and Ground

terminals.

NOTE

: This input is a 24-hour, silent terminal and the Panic phone call will be connected through the cellular

network.

Powering the LINKS1000 from a DC Source

The LINKS1000 (v3.0 and higher) has the capability to be powered only by a DC source. This could be useful

in such applications as: large recreational vehicles, motor homes, transport trucks, large boats, etc. In these

cases, the main power source is the vehicle’s battery and DC electrical system with no true AC source for the

control panel or LINKS1000 to draw power from.

To use the LINKS1000 with only a DC source, short jumper J2 and leave in place. Connect all wiring for the

LINKS1000 except for the power circuit. Once all connections are made, connect the vehicle’s DC source to

the battery leads of the LINKS1000 (observing correct polarity) and test the control panel and LINKS1000

according to the “Testing the System” sections of their respective manuals.

NOTE

: If the LINKS1000 is being used for such an application, the central station should be notified when the

vehicle is being serviced to avoid possible false alarms.

NOTE

: The LINKS1000, control panel and DC source should be in a physically secure location to avoid

possible tampering.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Sin comentarios

DSC PC1575 Manual de instalación Pagina 6