DSC PC1500 - REV8 Manual de instrucciones descargar pdf (Pagina 9)

Ready light ON - System is ready for arming.

Ready light OFF - System has an open zone

which must be closed or bypassed before

arming.

Memory light ON means an alarm has

occurred. Press [

∗

] then [3]. Zone light will

come ON to indicate which zone caused

the alarm.

Bypass light comes ON when you bypass

a zone. To bypass a zone, press [

∗

][1]

and then the zone(s) you wish to bypass.

Enter 1 for zone 1....6 for zone 6. Press [#]

to return to Ready.

Armed light will come ON indicating the

system is armed. To arm, ensure “Ready”

light is ON; enter 4 digit code.

Trouble light is ON when there is a fault in the

system. Press any key to silence the keypad

beeping. Press [

∗

] then [2] to display the

trouble type .

Zone Light Trouble Type

1............Low battery.

2............AC fail (buzzer does not sound).

3............Fuse open (BELL or AUX fuse).

4............Failure to communicate.

5............Fire loop(s) trouble.

6............Clock needs resetting.

Zone light(s) when ON in the disarmed

mode, indicate an open zone. e.g. open

door, window, etc. Refer to zone chart on

the keypad door for zone information.

THESE BUTTONS WILL NOT FUNCTION

UNLESS PROGRAMMED BY YOUR

INSTALLER.

Press [P] for 2 seconds to activate

PANIC transmission.

Press [A] for 2 seconds to activate

an AUXILIARY transmission.

Press [F] for 2 seconds to activate

FIRE transmission.

Press

[#].....

When an error is made in

entering code, then enter

code again.

To return to ready state

after using [

∗

] commands.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios