DSC Power832 PC5015 Manual de instalación descargar pdf (Pagina 14)

12

Power Up

correct; and check voltage at the far

end. Disconnect furthest item on

Keybus and work back measuring

voltage. The panel will provide around

550mA of current for powering

modules and detection devices.

Always keep this in mind when ex-

panding a system. If you need more

power, you should use a PC5204

module. This will provide an extra

1.0Amp of power.

You may be using some additional

modules with the Power832. Always

repower the control panel after adding

them onto the system. You will also

need to enable supervision, [*][8]

[5015][902]. Wait one minute then

enter [903]. The added modules

should now be displayed. Push the

[#] key when you have finished. If a

unit is not displayed in the [903],

check all of the connections for the

unit.

Initial Start Up

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comentarios a estos manuales

Sin comentarios