DSC Power832 PC5015 Manual de instalación descargar pdf (Pagina 27)

Features

Basic Programming

Now let’s look at how to change some

of the default settings listed on the

previous page. If you are using the

Power832 as a “bells only” system,

this could be the only programming

you need to do.

For example, let’s look at changing

the entry delay from default 30 sec-

onds to 45 seconds. Entry delay is in

section 005, “System Times”, on

page 4 of the Programming

Worksheets. All entries in section 005

require 3 digits.

To get into engineering programming

mode you must press [*][8] followed

by your engineering code. At default

this will be [5015]. At this point the

keypad will display “Enter Section”

followed by three dashes. Enter the

three-digit number of the section you

want to program, in this case [005].

You will see the digits 030 displayed

indicating the default time of 30

seconds. Enter [045] for the new entry

delay time. If this is the only change

you want in section 005, you can now

press [#] to exit this section and save

the change. If you want to make

another change, (“Exit Delay”, for

example), then use the arrow keys

until 120 is displayed (the default

setting).

Basic Programming

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Sin comentarios

DSC Power832 PC5015 Manual de instalación Pagina 27