DSC WLS900 Instrucciones de operaciones descargar pdf (Pagina 13)

3 G: Removing Components from the System

Follow the procedure below to remove components from the system. You may wish to remove

components for the following reasons:

• The component is no longer required on the system

• A mistake was made in enrolling the component

• The component is not working and requires service

Enter the Enrollment Mode as described in

3 B: Entering the Enrollment Mode

ADDING

COMPONENTS

When this message is displayed, press the

-YES Key.

Use the

-NO Key to scroll to this message.

When this message is displayed, press the

-YES Key.

Use the

-NO Key to scroll through the list

of components. A message similar to this

will be displayed for each component.

When the desired component is displayed,

press the -YES Key to remove the

component. The Sounders will sound a

single short beep and this message will be

displayed.

After a component is removed, this message

will be displayed. Press the

-YES Key to

remove another component, or press the

-NO Key.

To display the Serial Number of a

component, press the [

∗

] Key while viewing

the list of components. When the [

∗

] Key is

pressed, a message similar to the one shown

here will be displayed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Sin comentarios

DSC WLS900 Instrucciones de operaciones Pagina 13