DSC Power832 PC5O15 Manual de instalación descargar pdf (Pagina 22)

K E Y P A D C O M M A N D S

[24] - Recall Bypass Group #1

This function key will recall zones in Bypass Group #1. This group is programmed by the user in the [*][1]

Bypass menu. The function key will follow the Code Required for Bypass option. If the option is enabled, a valid

access code with the Bypass attribute enabled must be entered after the function key is pressed. For

instructions on zone bypassing and programming Bypass Groups, see the PC5015 Instruction Manual.

[25] - Recall Bypass Group #2

This function key operates similar to function key [24] but will recall zones in Bypass Group #2. For instructions

on zone bypassing and programming Bypass Groups, see the PC5015 Instruction Manual.

3.6 Global and Partition Keypad Operation

A global keypad will not display any information (the trouble LED will light if a trouble condition is present) until a

partition is selected. To select a partition the user must press and hold the [1] key for Partition 1 or the [2] key

for Partition 2 for two seconds. The keypad will then display the status of the selected partition and allow normal

operation.

A Partition keypad will display the status of the Partition for which it has been programmed. A user with access

to both partitions may temporarily assign the keypad to the other partition to gain access. To do this the user

must first press and hold the [#] key for two seconds. The keypad will go blank. The user must then press and

hold the [1] key for Partition 1 or the [2] key for Partition 2 for two seconds. The keypad will then display the

status of the selected partition and allow normal access.

3.7 Features Available for the LCD5500Z

These features are only available for LCD5500Z keypads with zone inputs:

Automatic Scrolling of Alarms in Memory

The LCD5500Z keypad allows automatic scrolling through alarms in memory while the keypad is idle. This

feature, if enabled, will override the clock display. This option can be programmed in LCD programming section

[66], option [4].

24 Hour Time Display Option

The LCD5500Z can be programmed to display time using a 24- hour clock, instead of a 12-hour, a.m./p.m.

clock. This option can be programmed in LCD programming section [66], option [3].

Keypad Zones

See section 2.10 “Keypad Zones”.

Viewing Troubles While Armed

See section 3.4 “[✱][2] Trouble Display” for information on how to view troubles.

Backlighting Boost (available for all zone input keypads)

The LCD5500Z, LCD5501Z, PC5502Z2 and PC55XXZ zone input keypads will provide extra number pad lighting

when any key is pressed. The backlighting boost will last for an additional 30 seconds after the last keypress.

Prompts for the following features are only supported by LCD5500(Z) v2.X:

• Downlook Support (DLM-4L/PC5108L): Active Camera Monitor Selection, Remote Trigger

• Auto Arm features: Late to Close, Auto Arm Postpone/Cancel, Auto Arm by day

• Bypass groups

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Sin comentarios

DSC Power832 PC5O15 Manual de instalación Pagina 22