DSC PowerSeries PC1832 Información técnica descargar pdf (Pagina 13)

5. Use the arrow keys ([< >]) to move the underline bar underneath the letter to be changed.

6. Press the number keys [1] to [9] corresponding to the letter you require. The first time you press the number the

first letter will appear. Pressing the number key again will display the next letter.

Refer to the following:

[1] - A, B, C, 1

[2] - D, E, F, 2

[3] - G, H, I, 3

[4] - J, K, L, 4

[5] - M, N, O, 5

[6] - P, Q, R, 6

[7] - S, T, U, 7

[8] - V, W, X, 8

[9] - Y, Z, 9, 0

[0] - Space

7. When the required letter or number is displayed use the arrow keys ([< >]) to scroll to the next letter.

8. When you are finished programming the Zone Label, press the [*] key, scroll to “Save,” then press [*].

9. Continue from Step 2 until all Labels are programmed.

Viewing the Event Buffer from a PK5500/LCD5500 Keypad

The event buffer will show you a list of the last 500 events that have occurred on your system. You must use an LCD

keypad to view the event buffer.

1. Press [*][6][Master Code].

2. To select Event Buffer viewing, press [*].

3. The keypad will display the event number, partition or area, and the time and date. Press [*] to switch between

this information and the event details.

4. Use the [< >] keys to scroll through the events in the buffer.

5. To exit event buffer viewing, press [#].

PK5500 Global Status Screen

When the keypad is loaned to global mode (pressing and holding the [#] key), you will see a Global Partition Status

screen. This shows basic status for up to 8 partitions, depending on the configuration of your system.

Each partition is identified by a number. Below each number is the current status of that partition.

A -

Partition is Armed

N -

Partition is Not Ready to Arm

R -

Partition is Ready to Arm

! -

Partition is in Alarmed

- -

Partition is Not Enabled

Sensor Reset

Certain sensors, after having detected an alarm condition, require a Reset to exit the alarm condition (i.e. glassbreak

sensors, smoke detectors, etc.). Ask your alarm company if this function is required on your system.

To reset the detectors, press and hold the Reset key for 2 seconds or press [*][7][2].

1 2 ... 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

DSC PowerSeries PC1832 Información técnica Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad DSC PowerSeries PC1832