All the keypads have an audible indicator and command entry keys. The LED keypads have a group of zone and system
status lights. The LCD keypad has an alphanumeric liquid crystal display (LCD). The keypad is used to send commands to
the system and to display the current system status. The keypad(s) will be mounted in a convenient location inside the
protected premises close to the entry/exit door(s).
The security system has several zones of area protection and each of these zones will be connected to one or more
sensors (motion detectors, glassbreak detectors, door contacts, etc.). A sensor in alarm will be indicated by the
corresponding zone lights flashing on a LED keypad or by written messages on the LCD keypad.
Maintenance
With normal use, the system requires minimum maintenance. Note the following points:
Do not wash the security equipment with a wet cloth. Light dusting with a slightly moistened cloth should
remove normal accumulations of dust.
Use the system test described in “Testing Your System” to check the battery condition. We recommend,
however, that the standby batteries be replaced every 3-5 years.
For other system devices such as smoke detectors, passive infrared, ultrasonic or microwave motion detectors
or glassbreak detectors, consult the manufacturer’s literature for testing and maintenance instructions.
Arm and Disarm the System
Arming (Turning On/Setting)
Close all sensors (i.e. stop motion and close doors). The Ready (checkmark) indicator should be on.
To arm, press and hold the Away key for two seconds and/or enter your Access Code, or press [*][0] to Quick Arm.
During the setting state (exit delay active) the Armed (lock) and Ready (checkmark) indicators will turn on, and the
keypad will sound one beep per second. To cancel the arming sequence, enter your access code.
Away Arming (Turned On/Set)
When the exit delay is completed, the alarm system is armed/set and this is indicated on the keypad as follows: the
Ready (checkmark) indicator will turn off, the Armed indicator will remain on and the keypad will stop sounding.
Quick Exit
If the system is armed and you need to exit, use the Quick Exit function to avoid disarming and rearming the system.
Press and hold the Exit key for two seconds or press [*][0]. You now have two minutes to leave the premises through
your exit door. When the door is closed again, the remaining exit time is cancelled.
Bell/Siren Sounds After Away Arming
Audible Exit Fault
In an attempt to reduce false alarms, the Audible Exit Fault is designed to notify you of an improper exit when arming
the system in the Away mode. In the event that you fail to exit the premises during the allotted exit delay period, or if
you do not securely close the Exit/Entry door, the system will notify you that it was improperly armed in two ways: the
keypad will emit one continuous beep and the bell or siren will sound.
Your installer will tell you if this feature has been enabled on your system. If this occurs:
(48 paginas)
(12 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales