DSC Power432 PC585 Manual de instalación descargar pdf (Pagina 55)

Programming Worksheets: 5.33 Daylight Savings Time

[997] View Software Version

[998] Initiate Global Label Broadcast

All LCD programming is done per keypad. If more than one LCD keypad are present on the system, and the PC5400 receives

labels, labels programmed at one keypad can be broadcast to all other LCD keypads. Perform the following procedure in order to

broadcast labels:

Step 1 - Program one LCD keypad completely.

Step 2 - Make sure all LCD keypads are connected to the Keybus.

Step 3 - Enter Installer’s Programming, then enter section [998] at the keypad that was programmed. The keypad will now broad-

cast all the information programmed to all the other LCD keypads on the system.

Step 4 - When the keypad is finished press the [#] key to exit.

[999] Reset LCD EEPROM to Factory Defaults

ASCII Characters

FCC COMPLIANCE STATEMENT

CAUTION: Changes or modifications not expressly approved by Digital Security Con-

trols Ltd. could void your authority to use this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-

able protection against harmful interfer-ence in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in ac-

cordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be deter-mined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Re-orient the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/television technician for help.

The user may find the following booklet prepared by the FCC useful: "How to Identify and

Resolve Radio/Television Interference Problems". This booklet is available from the U.S.

Government Printing Office, Washington D.C. 20402, Stock # 004-000-00345-4.

IMPORTANT INFORMATION

This equipment complies with Part 68 of the FCC Rules and the requirements adopted by

the ACTA. On the side of this equipment is a label that contains, among other information,

a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must

be provided to the Telephone Company.

Product identifier: US: F53AL01BPC580

USOC Jack: RJ-31X

Telephone Connection Requirements

A plug and jack used to connect this equipment to the premises wiring and telephone net-

work must comply with the applicable FCC Part 68 rules and requirements adopted by the

ACTA. A compliant telephone cord and modular plug is provided with this product. It is

designed to be connected to a compatible modular jack that is also compliant. See instal-

lation instructions for details.

Ringer Equivalence Number (REN)

The REN is used to determine the number of devices that may be connected to a telephone

line. Excessive RENs on a telephone line may result in the devices not ringing in response

to an incoming call. In most but not all areas, the sum of RENs should not exceed five

(5.0). To be certain of the number of devices that may be connected to a line, as determined

by the total RENs, contact the local Telephone Company. For products approved after July

23, 2001, the REN for this product is part of the product identifier that has the format

US: AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal

point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the

label.

Incidence of Harm

If this equipment PC580 causes harm to the telephone network, the telephone company

will notify you in advance that temporary discontinuance of service may be required. But

if advance notice is not practical, the Telephone Company will notify the customer as soon

as possible. Also, you will be advised of your right to file a complaint with the FCC if you

believe it is necessary.

Changes in Telephone Company Equipment or Facilities

The Telephone Company may make changes in its facilities, equipment, operations or pro-

cedures that could affect the operation of the equipment. If this happens the Telephone

Company will provide advance notice in order for you to make necessary modifications to

maintain uninterrupted service.

Equipment Maintenance Facility

If trouble is experienced with this equipment PC580, for repair or warranty information,

please contact the facility indicated below. If the equipment is causing harm to the telephone

network, the Telephone Company may request that you disconnect the equipment until the

problem is solved. This equipment is of a type that is not intended to be repaired by the end

user.

Simplex Time Recorder Co. 100 Simplex Drive, Westminster MA 01441-0001 USA, Tel:

(978) 731-2500

Additional Information

Connection to party line service is subject to state tariffs. Contact the state public utility

commission, public service commission or corporation commission for information.

Alarm dialing equipment must be able to seize the telephone line and place a call in an

emergency situation. It must be able to do this even if other equipment (telephone, answer-

ing system, computer modem, etc.) already has the telephone line in use. To do so, alarm

dialing equipment must be connected to a properly installed RJ-31X jack that is electrical-

ly in series with and ahead of all other equipment attached to the same telephone line.

Proper installation is depicted in the figure below. If you have any questions concerning

these instructions, you should consult your telephone company or a qualified installer

about installing the RJ-31X jack and alarm dialing equipment for you.

Telephone

Computer

Telephone

Fax Machine

Alarm Dialing

Equipment

RJ-31X

Jack

Unused

RJ-11 Jack

Telephone

Line

Network

Service

Provider's

Facilities

Customer Premises Equipment and Wiring

Unused

RJ-11 Jack

Network

Demarcation

Point

Answering

System

1 2 ... 50 51 52 53 54 55 56

Comentarios a estos manuales

Sin comentarios

DSC Power432 PC585 Manual de instalación Pagina 55

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad DSC Power432 PC585