DSC PC5020 Manual de instalación descargar pdf (Pagina 46)

Programming Sections: 5.11 Special Installer Instructions PWS Sect 11

[991][Installer Code] - Installer Lockout Disable

This disables the Installer Lockout feature described above.

To disable Installer Lockout perform the following:

1. Enter Installer Programming.

2. To disable Installer Lockout, enter section [991].

3. Enter the Installer Code.

4. Enter section [991] again.

[993]-[999] Factory Defaults

On occasion it may be necessary to default the main control panel or

one of the modules that can be connected. There are several differ-

ent defaults available including defaulting the main control panel,

Escort5580 module, PC5132 Wireless Expander Module, PC5400

Printer module and LINKS2X50 module.

NOTE: Defaulting the main panel does not default the keypads.

Refer to the Programming Worksheets Appendices A and B for

instructions for defaulting LCD5500Z and LCD5501Z keypads.

PC55XXZ LED keypads must be manually reprogrammed in program-

ming section [000].

Factory Default Main Panel (Hardware)

1. Remove AC and battery from the panel.

2. Remove all wires from the Zone 1 and PGM1 terminals.

3. With a piece of wire short the Zone 1 terminal to the PGM1 ter-

minal.

4. Apply AC power to the main panel.

5. When Zone Light 1 is lit on the keypad the default is complete.

6. Remove AC power from the control

7. Reconnect all original wiring and power up the control.

NOTE: AC power must be used to power the panel. The panel will

not default if the battery is used.

Factory Default Main Panel (Software) and other

Modules

1. Enter Installer Programming.

2. Enter the appropriate programming section [99X].

3. Enter the Installer Code.

4. Enter the appropriate programming section [99X] again.

The panel will take a few seconds to reset. When the keypad is oper-

ational, the default is complete.

[993][Installer Code] - Restore Alternate Comm. Fac-

tory Default Programming